From the
Refine section of the
action bar,
click
Chamfer.
Select a sharp edge.
Tips:
From the list, you
can define which type of edges are to be selected, and then click
Automatic selection to automatically select all corresponding edges.
When no edge is selected, you can use
the
Selection filter.
To create a
longitudinal chamfer, select a single long edge. This allows you to create a
welding chamfer, for example.
The chamfer is previewed on the edge and is automatically
propagated to the tangent edge.
Choose the chamfer type and define the associated values for each
parameter.
Option
Description
Length1 / Length2
Enter two lengths values.
Length1 / Angle
Enter a length value and an angle value.
You can click
Reverse
to invert the parameter side.
Select another edge on the part and click
OK.
Selected sharp edges of the 3D shape are cut off or filled
in.
Warning:
If a sharp edge is
selected in the thickness of the wall, its length must be equivalent to the
wall thickness.
If the sharp edge
is not selected in the thickness of the wall, it must limit the faces of the
wall.