-
In the Outer Boundaries section, select curves or surface edges to
form the outer closed boundary.
-
Optional: In the Inner Boundaries section, select
inner curves or surface edges to form the inner closed boundary.
-
In the table containing the list of elements, you can:
-
Click  to add a line
at the end of the list.
-
Click  to insert a
line before the selected line.
-
Click  to insert a
line after the selected line.
- Click
 to remove all the
lines.
-
Optional: Click Add Boundary to add a new boundary
or click <cross icon> to remove the selected boundary.
- Optional:
For both the sections, you can select a support surface for each curve or edge. In
this case, the continuity will be kept between the fill surface and selected support
surfaces.
Note:
You can define a support just after the selection of the curve or by clicking the
curve in the list and selecting a support. To be able to select a support, the boundary
must completely lie on the support.
- Click OK to create the fill surface.
The surface (identified as Fill.xxx) is
added to the tree.
|