Surface Section

The primary area of the Surface section provides commands for creating surfaces using different techniques.



Extrude
Creates an extruded surface by extruding a profile along a given direction.
See Creating Extruded Surfaces.


Sweep
Creates a swept surface by sweeping out a profile in planes normal to a spine curve.
See Creating Swept Surfaces.


Fill
Creates a fill surface between boundary segments.
See Creating Fill Surfaces.


Multi-Sections Surface
See Flyout for Multi-Sections Surface.


Unified Patch
Creates a patch from two, three, or four points, and allows projection as well as fitting of the patch on its support.
See Creating a Patch from Points.


Patch from Patches
Creates a single patch from several adjacent patches.
See Creating a Patch from Patches .


Net Surface
Creates a surface based on an existing set of curves.
See Creating a Net Surface.

Flyout for Multi-Sections Surface



Multi-Sections Surface
Creates a multi-section surface by sweeping one or more section curves along an automatically computed or user-defined spine.
See Working with Multi-Sections Surfaces.


Blend
Creates a blended surface between two wireframe elements.
See Creating Blended Surfaces.