3DPipingTubing_Part_FoundInPartFilter

This check verifies whether the part was found in the part filter belonging to the specification. If not, an error is displayed.

This page discusses:

Context

To ensure the quality of the design, even if the specification has been modified, each part must belonged to the specification defined on the line ID. This check also verifies that the part still exists in the specification at the end of the design.

Note: The check also fails if:
  • The part is not in a line ID.
  • No specification is set on the line ID.

This check is used in a line ID driven design context.

Check Information

Check Details Description
Applicable to: Piping_Part_Occurrence
Automatic Solution:
Check Parameters: None