Cylindrical_Bend_Definition

This check verifies whether angles and radiuses of cylindrical bends are within the specified value range.

This page discusses:

Context

This check is used to verify that the minimum radius is smaller than the defined minimum radius. If the bend radius is too small, cracks or cuts may appear around the bend area, which can weaken the part.

Check Information

Check Details Description
Applicable to: ShmBend
Automatic Solution:
Check Parameters:
  • Minimum_BendRadius: Length type.

    Specifies the minimum bend radius allowed for the cylindrical bend.

  • Maximum_BendRadius: Length type.

    Specifies the maximum bend radius allowed for the cylindrical bend.

  • Minimum_Angle: Angle type.

    Specifies the minimum angle allowed for the cylindrical bend.

  • Maximum_Angle: Angle type.

    Specifies the maximum angle allowed for the cylindrical bend.