Non-Allowed_Overalapping_Feature

This check verifies whether certain types of drawing elements are overlapped by certain other drawing elements.

If so, these elements will be marked as incorrect. Only drawing elements situated on the same sheet is considered.

Note: To check the rule, at least one value must be selected in the Overlapped_Feature_Types.

This page discusses:

Context

An overlap between drawing elements occurs if their respective bounding boxes coincide partly or entirely.

Note: As the check verifies a lot of elements, try to use it sparingly to avoid having lots of errors.

Check Information

Check Details Description
Applicable to: DrwDrawing
Automatic Solution:
Check Parameters:
  • Overlapped_Feature_Types: Multi Value Parameter type
    • 2DCircle
    • 2DConcatenatedCurve
    • 2DConicCurve
    • 2DConnectCurve
    • 2DCstPoint
    • 2DCstPoint_Tangent
    • 2DCurve
    • 2DCurveEquation
    • 2DEllipse
    • 2DFixTogether
    • 2DFrozenSpline
    • 2DHyperbola
    • 2DLine
    • 2DParabola
    • 2DPoint
    • 2DPointOnCurve
    • 2DPolyline
    • 2DSplineCurve
    • 2DUnspec
    • AnnIndicatorEdge
    • AnnViewText
    • DrwAnnBroken
    • DrwAnnLabel
    • DrwArrow
    • DrwBalloon
    • DrwCallout
    • DrwCoordDimension
    • DrwDatumFeature
    • DrwDatumTarget
    • DrwDimension
    • DrwDimSystem
    • DrwGDT
    • DrwRough
    • DrwTable
    • DrwText
    • DrwView
    • DrwWelding
    • HlrView
    Note: By default, nothing is selected.