Ply_Draping_Direction_Must_Match_Ply_Group_Draping_Direction

This check verifies whether ply and ply group have the same draping direction or not.

Note:
  • The checks succeeds when draping direction of ply and ply group are the same.
  • The check fails when draping direction of ply and ply group are different.

This page discusses:

Context

Modifications to a Composites part may lead to inconsistent draping directions. As a consequence, the part cannot be processed in subsequent steps.

Tip:
  1. Edit the ply to change the draping direction.
    • If the draping direction of the ply is the same as the draping direction of the plies group, the arrow that represents the draping direction is green.

    • If the draping direction of the ply is not the same as the draping direction of the plies group, the arrow that represents the draping direction is red, with an attached diagnostic message.

Check Information

Check Details Description
Applicable to: CATCompPly
Automatic Solution:
Check Parameters: None