Sheet_Metal_Parameters

This check verifies whether the K-Factor, Default Bend Radius and Thickness of Sheetmetal parameter corresponds to one of the specified values.

This page discusses:

Context

This check validates the parameters used for any sheet metal part. If the K-factor, bend radius and thickness values are not correct, the unfolded length of the sheet metal parts will not match with the specifications. If you want to use the DIN formula, you can click DIN Calculation in the Sheet Metal Parameters panel.

Check Information

Check Details Description
Applicable to: ShePart
Automatic Solution:
Check Parameters:
  • Thickness tolerance: Real type.

    Specifies that the difference of thickness values must be within the tolerance value.

  • Default Bend Radius tolerance: Real type.

    Specifies that the difference of the default bend radius values must be within the tolerance value.

  • KFactor Tolerance: Real type.

    Specifies that the difference of the K-Factor values must be within the tolerance value.

  • Allowed KFactor values: List (Real) type.

    Specifies valid K-Factor values.

  • Allowed Thickness values: List (Real) type.

    Specifies valid thickness values.

  • Allowed Default Bend Radius values: List (Real) type.

    Specifies valid default bend radius values.