WallOnEdge_Definition

This check verifies whether the bend radius of the Wall on Edge feature corresponds to the specification.

This page discusses:

Context

This check is used to verify that the radius of the wall on edge is equal to the default bend radius defined during Sheet Metal parameter creation.

Check Information

Check Details Description
Applicable to:
  • ShmWallOnEdge
  • ShePart
Automatic Solution:
Check Parameters:
  • Minimum_radius_value: Length type.

    Specifies the minium radius value allowed for Wall on edge.

  • Handling_of_option_without_bend: String type.

    Select this option in case the “With bend” option is not selected for the wall on edge.

  • Equal_radius_to_default_bend_radius: Boolean type.

    Select this option if the wall on edge bend radius must match the default bend radius defined in the Sheet Metal parameters.

  • Allowed_radius_range: Boolean type.

    Select this option if the wall on edge bend radius must be within a specific value range.

  • Maximum_radius_value: Length type.

    Specifies the maximum radius value allowed for the wall on edge.