Creating an Arc Bend

You can bend mesh points on a subdivision object in an arc based on view orientation.

  1. From the Subdivision section of the action bar, create a 2D or 3D subdivision object.

    Note: A 3D subdivision box is used in this procedure.



  2. From the Subdivision section of the action bar, click Arc Bend .
    A command toolbar appears with the following commands:

    Command Description
    Command Icon On a subdivision object, when you launch a command with a command toolbar, the active command icon is displayed on the drag handle of the toolbar. In the screen capture above this table, the Arc Bend icon is shown.


    		Accept and Continue. Accepts the current result and continues in the current command.


    		OK. Accepts the current result and closes the command.


    		Cancel. Cancels the command.
    Note: Press Esc to exit the command, double-click to apply the current command and use the command again.
  3. Set the direction of the arc by selecting a plane.


  4. Select one or more points in the mesh.
  5. Drag the arc handles to create an arc bend in the subdivision.


  6. Click .