Creating Splice Plies from Producibility

Splice Plies from Producibility creates splice plies from the simulation results of Producibility for Hand Layup. The cut-pieces are created from the updatable curves built from the producibility simulation on the plies, and the material roll size of the material applied to the plies.

  1. Select the plies to create the cut-pieces.
  2. Enter the Fiber Mesh Parameters.
  3. Enter the Splice Parameters to create the parallel curves (in red below).
  4. Select Repeat using Material Roll Width to create all the cut-pieces in one shot.
  5. In the 3D area, click the blue arrow to orient the ply drop and the red arrow to orient the overlap.

    The orientations are the same for all splicing curves.

 

See Also
More help on this topic