- Activate the geometrical set where you want to create the rosette transfer curve.
-
Select a rosette.
-
Select the surface where the curve is created.
In most cases, it is the reference surface.
-
Select a passage point of the curve.
-
Select an orientation.
- Define a Maximum Deviation angle.
-
Click Preview.
- The Rosette is transferred at the selected point.
- A point-direction geodesic line is created at the selected point in the direction given by the transferred rosette at the selected point. Its length depends on the surface size.
- The Rosette is transferred at the end of the geodesic line. A new geodesic line is computed from there.
- These two steps are repeated until the geodesic line is stopped by a surface boundary, or intersects another geodesic line, or itself. This could be the case on a cylindrical surface.
- The process is repeated in the other direction from the selected point.
|