Editing Producibility Parameters from the Producibility Table

You can use Edit Producibility Table to manage the producibility information for all the plies and cut-pieces of the stacking from the Producibility Table. Some edition actions work on a single selection, whereas others support multiselection.

  1. Check the deformation value of the material applied to a ply.
    1. Select the line of the ply in the table.
    2. Check the status in the Max. Shear and Max. Dev columns.

      • No circle indicates that the deformation is below the warning value.
      • A yellow circle indicates that the deformation is between the warning and the limit values.
      • A red circle indicates that the deformation is above the limit value.

    3. Check the warning and limit values of the material.

      These values are part of the Materials properties in Composites Parameters.

  2. Select one row and click Create.
    A new producibility parameters set is created at the end of any existing sets for the selected ply.
  3. Select one row and click Edit.
    1. Edit the current producibility.
    2. Click Preview.
      The results for the simulation are added.
  4. Select one or several rows and click Delete.
    The selected producibility parameters sets are deleted.
  5. Select one row and click Copy, Cut or Paste to perform the corresponding actions.
  6. Select one or several rows and click Run.
    1. Select the Show results check box to display the simulation results in the graphic area. You have to select the plies one by one to see them.
    2. Select the Show multiple results check box to display the computed fiber propagation of all selected producibilities in one shot.
  7. Select several stacking entities in the work area or using Multi-Selection and click Edit.

    Notes:
    • The selected elements must have a producibility with the same manufacturing propagation type.
    • The list of editable parameters depends on the manufacturing propagation type.

  8. Still in the edition dialog box, select geometries to transfer and apply a category.