Relimiting Plies from Panel Limits

You can create or remove limitations of plies by the panel limits.

Note: This task is available in Composites Design and not available on manufacturing stacking.

Before you begin:
  1. Double-click the grid panel in the tree to edit it.
    1. Under Panel limits, click Add and select the curves that form the contour.
    The panel Limits are created under Grid Panel.

  2. From the Grid Design section of the action bar, click Limit/Unlimit Plies .
  3. Select the Ply group to process.
  4. Select the Panel.
  5. To limit plies, select Recreate limitation of plies from panel limits.
  6. To remove the plies limit contours, select Remove relimitation of plies.

A message informs you of the number of limit contours that have been removed or added.

The plies are relimited. A Limit Contour is created under the Composites Geometry of the plies.

Below are examples of possible relimitation of plies: