Using the Stacking Management in Selection Mode

You can use the Stacking Management in selection mode in the following commands.

  • Butt Splice Zone
  • Check Contour
  • Composites Corner
  • New Stacking Area
  • Flattening
  • Limit Contour
  • Material Excess
  • Multiple Core Samples
  • No Splice Zone
  • Numerical Analysis
  • Ply Data Export (IGES/DXF export of plies)
  • Edit Producibility Table
  • Skin Swapping
  • Splice Plies
  • Unfold Composites Entity

Notes:
  • From the Tools Palette, only Select Row from Cell is available.
  • Display > Columns, Filters > Rows, Check Contours > 3D Contours Full Check, Review, and Entity Preview are available.
  • For each run, you can select entities (one or several) only in one level.
    • You can see entities selected in another level only if it is a child level.
    • You can add entities on another level only if it is a child level.
  • Previously selected entities are highlighted in the table.
  • Review is possible on each entity level.

In the dialog box of a command, click Multi-selection of entities .
  1. In the dialog box that opens, click Stacking Management .
  2. Use Ctrl or Shift to select the required rows.

    Note: If you change the Entity Level during one selection run, the current selection is lost.

All the entities selected in the same level are stored. This selection is propagated to the original dialog box.