Creating Chamfers

You can create chamfers to cut off sharp edges of the shape, in both folded and unfolded views.

Before you begin: Create a panel or an extrusion.
  1. From the Model section of the action bar, click Chamfer .
  2. Select an edge that connects two lateral faces.
  3. From the Definition list, select the chamfer type.
    OptionDescription
    Two lengths The two lengths are computed from the selected edge on both sides.
    A length value and an angle The length is computed on one side of the edge and the angle from the chamfer limit on the same side.
    The chamfer is previewed on the edge.

  4. Drag the handles to modify the length or angle values.
  5. From the list, select the edge type.

    You can click Automatic selection to automatically select all corresponding edges. When no edge is selected, you can use the Selection filter .

    Note: You can click Reverse to inverse the side of all edges on which the values are taken into account.