-
Click
Plot root locus analysis
 .
-
If the wanted model is not selected, click
Edit
 and select the model.
-
In the
modelParam tab, click
select to select the values of the model
parameters used for linearization.
-
To edit the values of the selected parameters, click the
corresponding
grid,
Value,
Min,
Max, and
nPoints boxes and change the values.
-
In the
simulationSetup tab deselect
linearizeAtInitial and edit other simulation
options as needed.
-
In the
diagram tab, change the properties of the root
locus diagram.
-
In the
device tab, change the properties of the device
where figure is shown.
|