About Attachment and Alignment Line on Stiffener on Free Edge

You can position the stiffener on a free edge in the appropriate position with respect to the Panel/Plate. This also helps to assemble the parts faster and accurately.

Create an Attachment line on a Stiffener on the free edge according to this flowchart.

Satisfy the conditions of the connection-related feature creation on SFE, the Attachment line creates on a Stiffener that has a free edge.

Attachment Line gets created on Stiffener on free edge for below conditions;

  1. If Weld type is Tee-Profile or Tee-Profile-Panel
  2. Stiffener on free edge can join part and Panel/Plate could be Pilot part.
  3. Anchor point for the Stiffener section must be one of these;
    • Center Left
    • Center
    • Center Right
    • Gravity
    • Web Center Right
    • Web Center Left

This shows Attachment and Alignment line creation on SFE with anchor point position as Center.

For these cases, Attachment line and Alignment line gets created on Stiffener and Alignment line gets created on Panel/Plate. Attachment line and Alignment line can be edited through Attachment Line tab and Alignment line tab in Edit Features . Alignment Line tab in Edit Features for Stiffeners can change the Location, Offset, and length value of Alignment Line through this as the same as in Panel/Plate.



The attachment line and alignment line created on profiles have the same functionality and behavior with existing attachment and alignment lines on plates/panels.