About Profile Feature Data Models

There are stiffener design models, which have multicells and different limit types that did not support them correctly. This gives results with low accuracy. Now these rib models support multi-cell stiffeners, enhancing the accuracy of straightened rib in case with different angle of limits, and rolled profile marking features that transfer accuracy. This supports stiffeners, which have only planar start / end faces (Without EndCut). User for marking line transfers logic enhancement and is only applicable for rolled stiffeners.

Not supported case, Multicell stiffener.



These results show low accuracy and have different limit types.



  1. Curved Stiffener.
  2. Straightened Stiffener - Shapes are different with curved and straight.

Marking Feature Transfer for a rolled stiffener case.



  1. Alignment line location at the end of the curved stiffener - Minimum distance 50mm.
  2. Alignment line location at the end of the straightened stiffener - Minimum distance 34.292mm.

Now with higher accuracy, the limit types.



  1. Bent result with weld limit type.
  2. Straightened result.
  3. Bent result with weld limit type - Minimum Distance 50mm.
  4. Straightened result - Minimum distance 50.136mm.