Using Joint Angle Manipulation with Dynamic Clash

You can control the manikin's movements using forward kinematics with the available handles and verify clashes (collision).

Click Play to watch the video:

  1. Click Joint Angle Manipulation .
  2. Click the segment to move.

    Circles representing each Degrees of Freedom appear and the Dynamic Clash dialog box.



  3. Select Detect and Stop on Clash and move the segment.
    During forward kinematics manipulation, with this option, the clash appears with a red contour.

  4. Continue to move the segment.
    Note: Trying to move the clashing segment away from the clash of the simulated contour while the hand goes with the part. The segment does not move until it goes out of the part, without collision.

    This enables you to find a solution out of a problematic clashing environment.