-
From the Stock Creation panel, select Cylindrical
Stock
in the
Mode box.
-
Select the Part Body on which the Cylindrical
Stock is to be created.
-
Optional: Modify the Axis values.
-
Optional: In the Parameters area, define the
additional parameters.
Note:
The Total Length parameter can be as follows:
- Locked: The manipulators are renamed
Position.1 and Position.2. You can
either modify the positions values or the total length value. If you modify the
positions values, the cylinder is only moved according to the cylinder axis and the
total length remains unchanged. If you modify the total length value, the difference
compared to the computed total length value is added or subtraced to the value of
Position.1.
- Unlocked: The manipulators are renamed
Offset.1 and Offset.2. If you modify
the offset values, the cylinder’s height is larger or smaller.This modifies the
total length accordingly. If you modify the total length value, the half of the
difference compared to the computed total length value is added or removed to the
value of each Offset.
|