You can display or highlight the interferences in slides and formats.
Before you begin:
- Display the required interference metrics as explained in the above task.
- Create a review and a review markup linked to the loaded
interference data.
Note:
If the review contains at least one markup, the
context is loaded based on the state of the Load Interference Simulation
with preference, saved at the time of markup creation. If no markup is
created, then the current state of the preference is considered. For more information,
see Table 9.
-
In the interference panel, select the required interference metrics as a context for
the slide.
Note:
You cannot change the context of the slide after the creation of the
slide.
The selected metrics are displayed in the widget.
-
From the Markup section of the action bar,
click Slide
.
- A new slide highlighting the selected interference metrics is created and its
thumbnail is added in the Slides panel.
- A new column is added in the interference panel to display the number of slides in
which the respective interference metrics are highlighted. If you click next to this number, all the slides associated with the respective interference
metrics are displayed one after another.
-
Add the required markup features to the slide and create formats from the
slide.
-
In the Slides panel, click to display the
thumbnails of the slides linked to the selected interference metrics.
The Slides panel displays the thumbnails of only those
slides that contain the selected interference metrics.