You can execute a built-in project synthesis, which analyzes the load of the CAN buses of
a project. It simulates information exchanges between the ECUs of a project and estimates the
impacts on the CAN bus load.
From the EE Tools section of the action bar, click Launch Bus Load Analysis
.
A graphic view appears, it contains the results of the dynamic analysis:
A tab with information as tables.
Tabs containing bus information. There is one tab per bus. For each bus,
three diagrams about the CAN communications through the embedded EE
architecture of a vehicle appear:
Diagram
Description
Transmission delay
A bar graph representing the transmission
delay (the
Min.,
Average, and
Max. for each frame)
Bus load
A pie chart representing the bus load
Load distribution per frame
A pie chart representing the distribution by
frames