-
In the work area,
select one of the following:
- A product. The branches from every electrical branch geometry within the product
are selected.
- An electrical branch geometry. All the branches within the electrical branch
geometry are selected.
- A branch.
The Robot is snapped to the network. In the 3D area, your
selection is highlighted and an icon is displayed on impacted route elements:  .
In the Network Duplication Assistant panel, your
selection is listed in a table. The electrical branch geometry in which your selection
will be copied appears under the Target column. - Optional:
Modify your selection:
- To add elements, select a product, an electrical branch geometry, or a branch.
- To remove elements, click Remove
 .
- To modify the electrical branch geometry set as target, click Edit
Target
 , and then select
another electrical branch geometry in the work area.
- Optional:
Modify the orientation of the Robot.
-
Position the selected network using a geometrical element:
-
Select the preferred direction of the Robot.
-
In the 3D area,
select a geometrical element.
A preview displays the intersection between the selected network and the
element:
-
Click the geometrical element to place the network at the intersection point, and
then use the offset editor to adjust precisely the position of the network.
-
Click Duplicate and close the panel.
The selected branches are duplicated. In the tree, duplicated branches appear under the electrical branch geometry set as target.
|
.