Copying Arrangement between Supports

You can copy the arrangement of segments from a source support to a target support.

Note: Copy Arrangement is not available for retainer supports.

  1. Select the source support.
    • The source supoort is highlighted as well as all the branches routed via this support.
    • The valid target support turns yellow. The target support can also be validated by the business rule if it exists.


  2. Click to deselect / reselect the branches passing through the source support, if you intend to filter out only these branches that you want to copy or not copy.
    Important: To allow the copy arrangement of segments from a source support to target supports, the target support should meet at least one of the following requirements:
    • The target support has the same segment routed through it which has been selected in source support for Copy Arrangement.
    • The target support has one segment passing through it whose parent branch is same as that of selected segment in source support for Copy Arrangement.
    • If the parent branch of the selected segment passing through the source, and the parent branch of segments in the target support are different, therefore a one-to-one electrical link (distant / non-distant) exists between these two branches.
  3. Select the target support.
    • The target support turns blue.
    • The arrangement is copied to the target support.
    • Two arrows appear on the target support: you can invert U and or V directions by clicking the arrows to fine tune the copied arrangement.




  4. Click in the work area to validate.