Synchronizing Cables with Cable Routes | |
| |
-
In the tree, select an electrical physical system.
- In the Cable Management Assistant panel, your cables are
listed in the Cable View tab, and their cable routes are
listed in the Cable Route View tab.
Tips: - Click
to display in the Cable Route View only the cable
routes owned by the cables selected in the Cable View
tab. - Press Ctrl and click a tab to display the content of both tabs simultaneously.
- Click
- In the 3D area, a
color is applied to the cable routes to distinguish their synchronization
status.
Important: The colors appear only when one single cable is selected. If you select several cable routes, colors appear only if the cable routes belong to the same cable. Whenever you perform an action impacting the synchronization status of a cable route, the color is updated in the 3D area.
- In the Cable Management Assistant panel, your cables are
listed in the Cable View tab, and their cable routes are
listed in the Cable Route View tab.
-
To manage the itinerary of your cable routes, use the following commands:
- Routing Assistant
- Associate Junction points
The statuses of your cable routes are updated according to your actions in the Cable Route View tab.When new routing information is ready to be synchronized, the following label appears in the Sync Status column in the Cable View: Updates Available.
- Routing Assistant
-
To synchronize your cables with your cable routes, select a cable or a cable route, and
then click Synchronize Cables
.
Important: Only cable routes that have a Fully Validated status can be synchronized with their cable.