Loading Objects Related to Cables

You can load in your session only the devices and cable routes that are significant in the routing process of your cables.

  1. From the Cable section of the action bar, click Load Related Objects .
  2. In the tree, select an electrical physical system.

    Tip: You can also select:
    • Cables
    • Cable Routes

    Multiselection is available.

    The Load Related Object panel appears.
    • If an electrical physical system is selected, all the cable routes aggregated under it are listed.
      Important: Only the cable routes of cables loaded in the session appear in the panel.
    • If a cable is selected, its cable routes are listed.
    • If a cable route is selected, only this object is listed.

    Information about the end devices of your cable routes is available in the From End and To End columns.

    • An empty cell indicates that an extremity is not defined.
    • Not Loaded indicates that the end device is not loaded in your session.

  3. Select one or several cable routes, and then click Load in Session.
    The devices defined as the extremities of the selected routes are loaded. As a consequence:
    • The loaded devices now appear in the structure of the tree.
    • All cable routes connected to the loaded devices are refreshed.
    Tip: In the Message column, information about the success or failure of the operation is provided.
  4. Close the panel or press Esc.