Connect a Route End to a Component
Before you begin: In a diagram view:
- Instantiate a symbol with a connection point
- Instantiate a route line with at least on end unconnected. For more information, see Routing a Route with an Unconnected Extremity.
-
From the
Layout section of the action bar,
click Connect Symbols
.
The command is active. -
Select the connection point of the component to be connected.
Tip: You can also click Port Mapping 
and select a port in the Available Ports for Mapping dialog box. Note: If both ends are unconnected, the route end closest to your pointer is selected. The selected end is highlighted by a green circle. -
Select the
route unconnected end.
The route end is connected to the component.
.
