About Electrical Components in the Spreadsheet

The Spreadsheet is a table allowing for the management of Requirement, Functional and Electrical content within the application. You can browse and change the structure of the harness loaded in session, edit the properties of its components and create new objects.

This page discusses:

Electrical Attributes managed in the Spreadsheet

The Spreadsheet is integrated into the Electrical Systems Design app, you have access to the same Electrical Systems Design commands in this table, but you can still activate them from the action bar even if the object is selected in the Spreadsheet.

The following table lists the properties you can add or modify in the Spreadsheet:

Equipment Connector ComponentBusbar ComponentConnector PortPinNet and Net groupWireCableCable groupHarness
Subtype
Predefined part number
Predefined Part Type
Classification
Connected Component
Order
Gauge / Contact gauge
Cable Family
Separation code
Nominal section
Minimum section
Maximum section
Number of Conductors
Nominal Current
Nominal Voltage
External diameter
Section
Routing priority
Maximum number of wires
Weight
Direct routing
Bend radius
Cross-section
Linear mass
Color
Routing Priority
Number of conductors by group
Number of group
Group type
Conductors colors
Conductors identifier
Number of conductors by pole
Number of poles
Number of neutral conductors
Neutral cable reference
Ground cable reference
Cable reference
User length*
Routed length (read-only)*
Segregation*

* User length, routed length and segregation are available for instances only.

Electrical Objects managed in the Spreadsheet

The following table shows you which electrical components can be created under which object in the Spreadsheet:

This component...can be created under...
EquipmentConnector ComponentHarness*Cable GroupCableWireNet GroupNetLogical ComponentConnector PortPinLogical Port
Equipment
Connector Component
Busbar
Harness
Cable Group
Cable
Wire
Net Group
Net
Connector Port
Pin

* Automatic harness content link