About Item Markups

Item markups list the modifications to the attributes shown in the properties tab when you open a production phase part. The item markups appear in the Markups tab. Item markups do not appear and are not available for development phase parts or configured parts.

Any member of the responsible design organization can create item markups. These markups follow the engineering change process and must be applied, rejected, or deleted before the change order reaches the Released state. See Markups Related to a Part.

Item markups can be managed through the Proposed Changes page of a change object. See Proposed Changes Page.

This page discusses:

See Also
Creating an Item Markup

Approve an Item Markup

Users assigned to the Design Engineer or Senior Design Engineer role can promote an item markup so that its related change object can move to the next state in the production lifecycle.

Reject an Item Markup

Users assigned to the Design Engineer or Senior Design Engineer role can reject an item markup so that it has no effect on the part. You reject item markups that are in the Proposed state. The system then promotes them to the Reject state.

Apply an Item Markup

Users assigned to the Design Engineer or Senior Design Engineer role can apply item markups so that the indicated changes take effect. The system promotes the item markup to the Applied state.

You apply approved item markups that are associated with a change object in the Frozen state. You must apply all approved item markups for a change object before it can be promoted to the Completed state. After you apply an item markup, the owner changes to Corporate and the item markup is made read-only.