Load Interference Simulation
with |
The preferences to open the interference simulation. |
Interference Display |
The preferences to display the interferences as per system
status (Clash or Contact),
quantifiers, and apply colors on interfering parts.- Geometries
- Quantifiers:
- Penetration volume: Select this check box to display the penetration volume if computed.
- Penetration vector: Select this check box to display the penetration vector and the penetration depth value in the work area.
- Minimum distance: Select this check box to display the minimum distance in the work area.
- Color Overloading:
|
Measure |
Select the Remove previous non-persistent
measures check box to remove the previously created non-persistent
measures when creating additional measures. By default, this check
box is cleared. |
Section |
The preference to display the contour at the
section. Select the Compute contour check box to
compute and display the contour at the section. By default,
this check box is cleared. In the Main value
display table select the respective options in the
Measure type and Unit columns
for available measurement types. These options control the measure value
representations that are displayed in the measurement markers. |
Move |
- First assembly level: If this option is selected,
the first assembly level is moved by default.
- Leaf part: If this option is selected, the leaf
part is moved by default.
By default, this option is selected.
|
Units |
Lets you specify the units for length, angle, volume, and
area values. Select the Display trailing zeros check
box to display the trailing zeros in the work area. Note:
For the interference result list and the exported interference result
file, trailing zeros preference is not considered.
By default, this check box is cleared. |
Display |
The preferences to display the content in the dashboard.
- Gravitational effects during navigation: This check
box lets you consider the gravitational effects while manipulating the
viewpoint.
By default, this check box is cleared.
- Projection Type: Under this area, you can specify
the projection type to display the object. You can select the
Parallel or the Perspective
check box to specify the projection type.
By default, the
Perspective check box is selected.
|
Selection |
Select 3D geometry inside the part, when
available: Lets you select the 3D geometries instead of 3D Parts
or 3D Representations. |