Inertia File-based Design Import

File-based Design Import (FBDI) enables content migration from V5 to 3DEXPERIENCE.

The following table describes import correspondences between V5 file-based data and 3DEXPERIENCE content for V5 Part containing inertia measure data.

Important:
  • Inertia features that belongs to a V5 Product are not persistent and are not saved in a CATProduct.

    Therefore they cannot be imported.

  • Inertia features that belongs to a V5 Part are persistent and are saved in a CATPart.

    Resulting inertia measures are updated after the import, furthermore the data model is not the same in 3DEXPERIENCE:

    • The default density value is differently managed.
    • For inertia measure linked with a material, the material may have a different density in 3DEXPERIENCE.
    • Only imported bodies in Show space are accounted for imported measures and these measures are editable in 3DEXPERIENCE.

      If all the imported part bodies are in No Show space, inertia measures are imported but not editable.

    • New bodies added to the resulting representation after the import are not accounted for imported measures.
    • Most of 3DEXPERIENCE measures are computed in exact mode.
    • 3DEXPERIENCE measures take into account thread and tap volumes.

The statuses for import results are fully imported, partially imported, and not imported (-).

V5 Data Type 3DEXPERIENCE Content Type Import Result
Inertia volume that belongs to a part Inertia volume Partially Imported

Imported in the same Geometrical Set, under the representation corresponding to the part.

Only the following parameters are imported with an Inertia Volume:

  • Area
  • Volume
  • Mass
  • Gx
  • Gy
  • Gz
  • IoxG
  • IoyG
  • IozG
  • IxyG
  • IxzG
  • IyzG

Inertia surface that belongs to a part - -
Associated material Associated material Imported under the representation corresponding to the part.