Creating a Reinforcement

Reinforcement adds material to the outside of material volumes that it intersects.

  1. Select the profile to be used. It can be an open or closed profile.

    Tip: If no profile is defined, click Positioned Sketch to sketch the profile.

  2. To define the ceiling, enter a value in the Length box under ceiling.
  3. To define the opening, enter a value in the Length box under Opening.
  4. In the Width box, enter a value to define the width of the reinforcement.
  5. In the Fillet tab, select the Ceiling radius check box to fillet the top of the profile and enter a value to define the ceiling radius value.
  6. To define the wall, you can set one of the two options available from the Type list under Wall: