Working with Ribs and Posts
-
In the
Profile/Surface box of the
Rib.x dialog box, select a
sketch containing a number of points in the
geometry.
-
Under First Limit, in the Length
box, enter the value.
-
In the Posts tab, select the Create Posts at
points check box.
-
In the
Diameter
box, enter a value to define the rib post diameter which
must be greater than zero.
-
In the
Taper angle box, enter an angular value.
The taper angle applies to each rib post. A non-zero angle
results in the post taking the geometric form of a truncated cone.
-
From the
Reference list, select
First Limit.
-
Click
Limits and in the
First Limit tab, from the
Type list, select
To Plane/Surface.
|
