-
Set the deformation options.
- Diffuse deformation: Spreads the deformation over
the whole matched surface, not only to a limited number of control
points.
- Optimize continuities: Performs the deformation
by optimizing the user-defined continuities rather than according to the
control points and mesh lines.
- Select the first edge of the surface to be matched.
- Select the target curve for the first selected edge.
-
In the App Options panel, click Continuity
 to
visualize texts on the geometry.
-
Right-click a continuity label to change the continuity type (point, tangency,
curvature) or to modify the edge order.
- Continue selecting pairs of source and target curves to
be matched, as needed.
-
Click Apply.
If you selected four source edges and four curves, the match is
automatically computed.
- Click OK to create the multi-side match surface.
|
