Create a Styling Fillet between Two Surfaces
You can create a styling fillet between two surfaces using the different continuity and fillet types.
- Under the Options tab:
- In the Continuity area, click continuity.
- In the Fillet Type area, cancel the selection of Variable \ Partial Fillet .
- Select two surfaces.
- Click Apply.
- In the Continuity area, click continuity.
- Click Apply.
- To shrink the fillet, modify the start and end points of the intersection curve:
- In the Fillet Type area, click Variable\Partial Fillet .
- Drag the handles along the intersection curve towards the center of the fillet.
- Click Apply.
- Adjust the fillet radius to vary linearly along the length of the fillet:
- Click one of the radius values and change its value in the Edit dialog box.
- Click Apply.
- Adjust the fillet radius to vary non-linearly along the length of the fillet:
- Click one or several positions on the intersection curve.
- Define different radii at each inserted position.
- Click Apply.
- Click OK.