Note the following points:
- Construction elements contained in 2D geometry are displayed only
in the active view.
- To ensure that 2D geometry is not altered once it
is created, geometry edition is only allowed in the active view.
Therefore, if you want to edit or move 2D geometry, you need to make
the view active which contains the geometry. You can prevent 2D geometry from
being inappropriately moved (and distorted) in the active view by clearing
Allow direct manipulation check box from
tab.
- You can create as many 2D geometry elements of a given type as needed
by double-clicking the appropriate icon (instead of single-clicking
it).
- You can create detected constraints
automatically by clicking Create Detected Constraints
in the Sketch section of the action bar.
- You can view the created constraints
by clicking Show Constraints
in the View section of the action bar.