SmartPick dynamically detects the following geometrical constraints:
- Support lines and circles
- Alignment
- Parallelism
- Perpendicularity
- Tangency
- Concentricity
- Horizontality
- Verticality
- Middle point
You can choose whether or not to create the constraints detected
by SmartPick. To create the constraints, you can use either of the following ways:
- Select the Create detected and feature-based constraints
check box in
tab.
- From the Sketch section of the action bar, select Create Detected Constraints .
Furthermore, note that:
- When a constraint is detected by SmartPick, you can temporarily:
- Deactivate this constraint by keeping the Shift key pressed.
- Lock this constraint by keeping the Ctrl key pressed.
- In a Drafting context, you cannot create geometrical
constraints with extremities and midpoints of any generated line
element, except with generated curves.