You can create a multisections surface by sweeping one or more section curves along the
spine.
-
Select one or more planar section curves.
- Optional:
Select a support surface for each of the extremity section curve.
Note:
The boundary must fully lie on the support. The support surfaces must
not be parallel to the sections.
- Optional:
In the
Continuity list, select the continuity type
for each support surface.
-
Click
Preview.
-
Optional: Select one or more guide curves.
- Optional:
Select the support for extremity guide curves and select the continuity
type for each support surface.
-
Click OK.