Create a Multi-Sections Volume
You can create a multi-sections volume by sweeping one or more closed section curves along defined guide curves.
-
Select one or more planar section curves.
The curves must be continuous in point.
- Optional: You can select a support surface for each of the extremity section curve.
- Optional:
In the
Continuity list, select the continuity type
for each support surface.
By default, the continuity is set to Tangent.
-
If needed, select one or more
guide curves.
Important: Guide curves must intersect each section curve and must be continuous in point. - Optional: You can select a support surface for extremity guide curves and select the continuity type for each support surface.
-
In the
Spine
tab,
select the
Spine check box to use a spine that is
automatically computed by the program or select a curve to impose that curve as
the spine.
Important: The spine curve must be normal to each section plane and must be continuous in tangency. - Click OK to create the multi-sections volume.