Working with On/Off Sheet Connectors

Listing Unpaired Sheet Connectors

You can list all the sheet connectors that are not paired. The verification is done on all the sheet connectors loaded in session.


Before you begin: In a diagram view,
  • Create and place equipment.
  • Create and connect a duct to the equipment and end the other extremity as a sheet connector.
  1. In the Check Offsheets dialog box, select the Check all orphan offsheets in session option in the list.
  2. Select one or several routable.

    Note: The Group column provides the name of the routable's father or the associated line ID. The Resolved State column indicates if the sheet connector's text templates are up to date.

    Appear in the right area.
  3. The following actions can be performed:
    • To replace the displayed representation by the default representation (with unresolved text templates) defined in Data Setup, click Reset Sheet-Connector.
    • To highlight the selected sheet connector in the diagram view, click Switch to View.
    • To route the other extremity of the selected routable, click Complete Route, and then select a connection point. Click the diagram view to place the sheet connector.