Moving Components Already Placed in the Diagram View

You can move a component already placed in the diagram view, and that is connected or not connected to other elements.

You can insert it on the following elements:

Before you begin: For this scenario, open a diagram view containing:

A component connected to two other components by two ducts belonging to the same line ID.
A component connected to a duct that ends in space.

On the context toolbar, click Move Component .
The component is disconnected from the pipe and follows your pointer. Since the two ducts belong to the same line ID, they are merged.
Move your component over the unconnected end of the third duct.

The duct route line is highlighted.
Click the route end to insert the component.
The component is connected at the end of the unconnected duct route line.