End Style

This section describes the End Style tables and how you can customize them.

This page discusses:

Overview

This resource file is a discrete list of all possible end styles that can be used for a duct for a single standard.

In Data Setup, this table should be assigned to:

  • when using file-based tables, the End Style item in the resource table of HVAC Design Resources with a Standard criteria.
  • when using Engineering Specification objects, the End Style item in the resource table of HVAC Specification Resources with a Standard criteria.

Table Description

To customize the table, enter all possible end styles of a duct for a single standard.

Important: You must create one table for each standard that you use.

File-Based Table

A typical End Style file-based table is shown below:

B-NUT
FLARED SLEEVE
FLARED TUBE
FLARELESS MALE
FLARELESS SLEEVE

Engineering Specification Table

A typical End Style Engineering Specification table is shown below:

End Style
B-NUT
FLARED SLEEVE
FLARED TUBE
FLARELESS MALE
FLARELESS SLEEVE

The column definition is as follow:

Column NameColumn TypeLink to TableLink to Column
End StyleString- -

The table has the following attribute:

  • Standard

Sample Resource File

The default location of Tubing_SSTL_EndStyle.xls is

..\startup\EquipmentAndSystems\HVAC\Standard\SSTL\

Where Used

Used in this appWhenIs seen as
HVAC 3D DesignCreating partsEnd Style list in Typed Part dialog box.
HVAC 3D DesignCreating objects using Add > ContentAttributes in the dialog box.
HVAC 3D DesignEditing propertiesAttributes in the dialog box.
HVAC 3D Part DesignUsing the Port Attribute Management optionAttributes in the dialog box.