Mapping Part Subtype

This section describes the Mapping Part Subtype tables and how to customize them.

This page discusses:

Overview

This table allows you to identify for each logical type the corresponding physical type.

In Data Setup, this table should be assigned to:

  • when using file-based tables, the Mapping Part Subtype item in the resource table of HVAC Design Resources.
  • when using Engineering Specifications objects, a specification in the resource table of HVAC Specification Resources.

Table Description

All the attribute values must be of the type of string.

File-Based Table

A typical Mapping Part Subtype file-based table is shown below:

Logical Branch Tee
Logical ReducerConcentric Reducer
Logical ReducerEccentric Reducer
Logical Valve
Logical Control ValveControl Valve
Logical Block ValveBall Valve
Logical Check ValveCheck Valve
Logical Isolation ValveGate Valve
Logical Pressure Relief Valve Pressure Safety Valve
Logical Safety ValveGlobe Valve
Logical Stop Check ValvePlug Valve
Logical Switch ValveButterfly Valve
Logical Throttle ValveGlobe Valve
Logical Adaptor
Logical Drain
Logical Expander Concentric Reducer
Logical Filter
Logical Terminator Cap
Logical Vent
Logical Piping Component
Logical Valve Operator
Logical In-line Instrument
Logical Piping Nozzle

Engineering Specification Table

A typical Mapping Part Subtype Engineering Specification table is shown below:

Logical Part SubtypePhysical Part Subtype
Logical Branch Tee
Logical ReducerConcentric Reducer
Logical ReducerEccentric Reducer
Logical Valve
Logical Control ValveControl Valve
Logical Block ValveBall Valve
Logical Check ValveCheck Valve
Logical Isolation ValveGate Valve
Logical Pressure Relief Valve Pressure Safety Valve
Logical Safety ValveGlobe Valve
Logical Stop Check ValvePlug Valve
Logical Switch ValveButterfly Valve
Logical Throttle ValveGlobe Valve
Logical Adaptor
Logical Drain
Logical Expander Concentric Reducer
Logical Filter
Logical Terminator Cap
Logical Vent
Logical Piping Component
Logical Valve Operator
Logical In-line Instrument
Logical Piping Nozzle

The columns definitions are as follow:

Column NameColumn TypeLink to TableLink to Column
Physical Part SubtypeStringPhysical Part Subtype Part Subtype
Logical Part SubtypeStringLogical Part subtype Part Subtype

The table has the following attribute:

  • Standard

Sample Resource File

The default location of XXX_L2PMapping.xls is:

..\startup\EquipmentAndSystems\HVAC\LogicalToPhysical\

Where Used

This resource file is used and seen here:

Used in this appWhenIs seen as
Generative Fluid 3D Designusing:
  • the Logical to Physical option
  • the Part Placement by Logical Driven option