-
Click Insert/Delete
.
-
Move the pointer on the curve and press Insert to insert segment boundaries at the selected positions.
-
Move the pointer on the curve and press Delete to delete segment boundaries.
-
Clear Insert/Delete
and click Trim
.
Note:
This trim option creates a datum element and not an OmniCut feature.
- Trim the curve at a segment boundary keeping one side.
- Move the pointer to a segment. The curve region kept after the trim operation is highlighted.
The pick position nearest to the next segment boundary determines the side to be kept.
- Click the segment to trim the curve.
- Trim the curve at a segment boundary keeping both sides.
- Move the pointer to a segment boundary. The whole curve is highlighted. To distinguish left and right side of the limitation, different highlight properties are applied.
- Click the segment boundary to trim the curve.
-
Clear Trim
and use the Segment Numbers box to insert segment boundaries.
If Segment Type Manual is selected, the segments are equally spaced along the curve.
At the curve ends are displayed continuities.
-
Click the continuity label at one of the curve ends to select the continuity to be kept at this side when modifying the inner segment boundaries.
-
In the Segment Modeling panel or the More section of the Sculpt panel, select Segment Type Arc Length.
Ratio determines the segment distribution:
-
Set the Ratio 0.0 (Arc Length).
The segments are equally spaced along the curve.
-
Set the Ratio 1 (Curvature).
The segments are distributed depending on the curvature degree.
This may cause a deviation from the original curve which is displayed at the curve and in Deviation in the context menu.
-
Move the pointer on the curve and press Alt + right-click.
-
In the mouse menu, select 1/3 Curvature.
The Ratio value in the Sculpt panel is set to 0.33.
-
Click Order
or , respectively, to change the order accordingly.
-
If deselected, click Analysis
to display the curvature analysis.
-
Modify the view and then a segment.
The curvature analysis is displayed in the original direction.
-
Undo the segment modification and click Curvature Analysis Auto Direction
.
-
Repeat the segment modification.
The curvature analysis is displayed according to the moved direction.
|