Filling Holes

You can use the extrusion command to fill holes.


Before you begin: Click Extrusion and select a surface.
See Also
In the Knowledge Base
Propagation of Edges to Fill a Surface
From the Tools Palette, click Fill , and do one of the following:
  • Select any border to fill the hole.
    Filling with 3 edges



    Note: When the Fill mode is activated, the join of two sets of edges is automatically detected. When the number of edges differs in both sets, only edges of the smallest set are joined. Therefore several resolutions may be possible.

    The Previous Result or Next Result buttons let to choose the desired solution:

  • Press Shift and draw a trap.

    In our example, we drew two traps:



    Here is the result: