Note:
You cannot sweep profiles along edges.
When the sweep shape is projected onto the guide curve, the following
rules apply:
If the profile and guide curve intersect, the point of intersection on
the profile follows the guide curve during the sweep.
If the profile and guide curve do not intersect:
- Closed profiles - the center of gravity of the profile follows the
guide curve during the sweep.
- Open profiles - the point on the profile closest to the guide curve
follows the guide curve during the sweep.
The
Selection panel lets you:
- Generate a sweep on a guide, profile, or complete guide. Manipulators
are no longer available.
- Use the begin- and end-point options to determine where the sweep
starts and ends. In the example opposite, the values are 10 (begin point) and
65 (end point).
- Switch end point with begin point.