Publishing the Angle of a Draft

You can publish the angle value of a draft as a parameter in the tree.

  1. Select a neutral face to draft and click Draft.
  2. From the selection bar, click Publish the angle value.
    The draft angle parameter is visible in the tree.

  3. The following options are available in the selection panel in publication mode:
    OptionDescription
    Draft Angle Editor Use the spinner or angle picker to modify the draft angle
    Note: The command must be validated to update a model.
    .
    Pulling Directions Click to revert the draft direction. Click to select an edge or a line for the pulling direction.
    Angle with normal Edit an angle with normal.
    Angle around normal Edit an angle around normal.



  4. From the selection bar, click Unpublish the radius value to unpublish it.