Viewing the Study Results

You can view the results of a study as each set of design variables is run.

You can also view the results of a completed study, magnify the results view, and switch the results shown in the model plots.

This task shows you how to:

See Also
About Study Results

Monitor the Study Results

Before you begin: You must have a study actively running to monitor its results in Parametric Design Study or Design Exploration. You must have at least one set of completed results within a study to open them in Physics Results Explorer.
  1. In Parametric Design Study or Design Exploration, run a study; or, if a study is already running, click Monitor Study in the Simulate section of the action bar.
    The Monitor Study dialog box opens.
  2. In Physics Results Explorer, click Study Results in the Explore & Generate section of the action bar.
  3. When a study that you are monitoring completes, close and reopen the Study Results panel to refresh the view.

    Results are saved to the simulation object only when the study is completed. The refresh switches from the dynamic results presented while the study is running to the saved results.

Magnify an Image View

  1. Click an image in the Scatter Plot or Model Plots pane to show a magnified image.
    The magnified image is displayed at two times normal magnification.
  2. Drag the pointer to move the magnified area of the view.

When you select a different image for the view, the magnification returns to normal.

View Model Plots

You can change the plot displayed in the Model Plots pane.

From the list at the top of the Model Plots pane, select a plot to view.
The selected plot opens in the Monitor Study or Study Results dialog box.