Synchronizing Data with Planning for a Manufactured Product
- Click an object, and from the Authoring section of the action bar, click Synchronizing Data with Planning
. The Programming Context dialog box appears. - Select Drill & Rivet and click OK.
The Synchronizing data with Planning panel appears. - Click Select the location to create Manufacturing Product and choose a location to instantiate the Manufacturing Product.
The Synchronizing data with Planning panel closes and you can select the location in the tree. - Run the command again to reopen the panel. Specify the requirements in the Manufacturing fastener creation options section of the Synchronizing data with Planning panel.
The Manufacturing fastener creation options section has two subsections: Action and Rivet Table. The Action subsection has three choices: - Update manufacturing fasteners and patterns: To create manufacturing fasteners related to all the design fasteners that are instantiated under a Manufacturing product. It then groups them into patterns based on their reference type.
- Update manufacturing fasteners: To create the manufacturing fasteners related to all of the design fasteners that are instantiated under the Manufacturing product. There is no grouping of patterns with this option.
- No action: To not create Manufacturing Fasteners.
The Rivet Table subsection has a command ... to select the Rivet table from the data, which is based on the parameters of the created Manufacturing Fasteners. - Click OK.
This creates the planned Manufacturing Product as specified in the Synchronizing data with Planning panel for the Drill & Rivet Context. The Status in the Synchronizing data with Planning panel will display a green thumb to indicate an updated status.
|